PM Hi-Volt
Download PM HV 
user manual 
The PM Hi-Volt is the control to use if you want real high voltage model power. It can handle from 10 to 50V and 90 Amps continuously, making it possible to pass 4.5 kW of power. Because PM Hi-Volt was designed for hi performance marine applications, no brake or reverse is included. Also, because of the large voltage difference between battery and receiver, a BEC would have produced unusable amounts of current for servo operation. PM Hi-Volt therefore requires an auxiliary receiver battery. This of course makes PM Hi-Volt smaller and best of all cheaper.
Features
·
High Voltage (50 Vdc maximum,)
·
High variable current (120Amps for 10 secs, 90Amps continuous)
·
Programmed for maximum power output and quick response.
·
Very low on resistance (0.8mW
or 0.0008W)
for minimum heat loss.
·
Small package, lightweight. (~5g without leads)
·
Safe Start. Throttle must be passed below Neutral before PMHV will
activate.
·
Micro controller controlled full digital operation for proper performance
under adverse conditions (dust, moisture, electrical interference and
vibration).
·
Uses the very latest and best available surface mount components for the
highest possible power output from the smallest package.
·
Programmable for power & neutral positions, & ramp up if
required.
·
Accommodates all radios.
·
No Radio Signal failsafe. Goes to Neutral after 1/8th sec. without radio
signal, and flashes LED.
·
LED which shows radio signal failure, full throttle, neutral,
and assists in programming.
·
Programmable soft power up. Ramping can be from 0 sec to approx. 0.6 sec.
for full throttle range.
·
Switch less programming.
·
Brown Out detection.
Price
AUD $110 + postage.